HP E4510-48G Command Reference Manual page 875

Parameters
domain-id: RRPP domain ID, in the range 1 to 8.
ring-id: RRPP ring ID, in the range 1 to 64.
Description
Use the display rrpp statistics command to display RRPPDU statistics.
Note that:
If an RRPP ring ID is specified, the RRPPDU statistics for the specified RRPP ring in the specified
RRPP domain on the current device are displayed. If not, the RRPPDU statistics for all RRPP
rings in the specified RRPP domain are displayed.
If a certain port belongs to more than one ring, its RRPPDU statistics are collected and displayed
by ring.
When a ring transits from inactive status into active status, packet counting for the ring restarts.
Related commands: reset rrpp statistics.
Examples
# Display the RRPPDU statistics for ring 1 in RRPP domain 1.
<Sysname> display rrpp statistics domain 1 ring 1
Ring ID : 1
Ring Level : 1
Node Mode : Master
Active Status : Yes
Primary port : GigabitEthernet1/0/1
Packet
Direct Hello
------------------------------------------------------------------------------
Send 16424
Rcv 0
Secondary port: GigabitEthernet1/0/2
Packet
Direct Hello
------------------------------------------------------------------------------
Send 0
Rcv 16378
# Display the RRPPDU statistics for all rings in RRPP domain 2.
<Sysname> display rrpp statistics domain 2
Ring ID : 1
Ring Level : 0
Node Mode : Master
Active Status : Yes
Primary port : GigabitEthernet1/0/3
Packet
Direct Hello
------------------------------------------------------------------------------
Send 16924
Link Common Complete
Down Flush FDB Flush FDB Hello
0 0 1
0 0 0
Link Common Complete
Down Flush FDB Flush FDB Hello
0 0
0 0 1
Link Common Complete
Down Flush FDB Flush FDB Hello
0 0 1
Edge Major
Fault
0 0
0 0 0
Edge Major
Fault
0 0 0
0 0
Edge Major
Fault
0 0
3-5
Packet
Total
16425
Packet
Total
16379
Packet
Total
16925