Silent-Interface (Rip View) - HP E4510-48G Command Reference Manual

Send RIPv2 broadcast messages
Receive RIPv1 broadcast messages
Receive RIPv1 unicast messages
Receive RIPv2 broadcast messages
Receive RIPv2 multicast messages
Receive RIPv2 unicast messages
When RIPv2 runs on the interface in multicast mode, the interface will:
Send RIPv2 multicast messages
Receive RIPv2 broadcast messages
Receive RIPv2 multicast messages
Receive RIPv2 unicast messages
Examples
# Configure VLAN-interface 10 to broadcast RIPv2 messages.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] rip version 2 broadcast

silent-interface (RIP view)

Syntax
silent-interface { interface-type interface-number | all }
undo silent-interface { interface-type interface-number | all }
View
RIP view
Default Level
2: System level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
all: Silents all interfaces.
Description
Use the silent-interface command to disable an interface or all interfaces from sending routing
updates. That is, the interface only receives but does not send RIP messages.
Use the undo silent-interface command to restore the default.
By default, all interfaces are allowed to send routing updates.
Examples
# Configure all VLAN interfaces to work in the silent state, and activate VLAN-interface 10.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-100] silent-interface all
[Sysname-rip-100] undo silent-interface vlan-interface 10
3-25