Filter-Policy Export - HP E4510-48G Command Reference Manual

Table 5-4 display ripng route command output description
Field
Peer
Dest
via
cost
tag
Sec
"A"
"S"
"G"

filter-policy export

Syntax
filter-policy { acl6-number | ipv6-prefix ipv6-prefix-name } export [ protocol [ process-id ] ]
undo filter-policy export [ protocol [ process-id ] ]
View
RIPng view
Default Level
2: System level
Parameters
acl6-number: Specifies the number of an ACL to filter advertised routing information, in the range of
2000 to 3999.
ipv6-prefix ipv6-prefix-name: Specifies the name of an IPv6 prefix list used to filter routing information,
a string of 1 to 19 characters.
protocol: Filters routes redistributed from a routing protocol, currently including direct, ripng, and
static.
process-id: Process number of the specified routing protocol, in the range of 1 to 65535. This
argument is available only when the routing protocol is rip.
Description
Use the filter-policy export command to define an outbound route filtering policy. Only routes passing
the filter can be advertised in the update messages.
Use the undo filter-policy export command to restore the default.
By default, RIPng does not filter any outbound routing information.
With the protocol argument specified, only routing information redistributed from the specified routing
protocol will be filtered. Otherwise, all outgoing routing information will be filtered.
Neighbor connected to the interface
IPv6 destination address
Next hop IPv6 address
Routing metric value
Route tag
Time that a route entry stays in a particular state
The route is in the aging state.
The route is in the suppressed state.
The route is in the Garbage-collect state.
5-7
Description