Info-Center Monitor Channel - HP E4510-48G Command Reference Manual

Default Level
2: System level
Parameters
interface-type interface-number: Specifies the egress interface for log information by the interface type
and interface number.
Description
Use the info-center loghost source command to specify the source IP address for log information.
Use the undo info-center loghost source command to restore the default.
By default, the interface for sending log information is determined by the matched route, and the
primary IP address of this interface is the source IP address of the log information.
After the source IP address of log information is specified, no matter the log information is actually
output through which physical interface, the source IP address of the log information is the primary IP
address of the specified interface. If you want to display the source IP address in the log information,
you can configure it by using this command.
Note that:
The info-center loghost source command takes effect only after the information center is
enabled with the info-center enable command.
The IP address of the specified source interface must be configured; otherwise, although the
info-center loghost source command can be configured successfully, the log host will not
receive any log information.
Examples
By default, the log information in the following format is displayed on the log host:
<188>Jul 22 05:58:06 2008 Sysname %%10IFNET/4/LINK UPDOWN(l):
is UP
# Specify the primary IP address of VLAN-interace1 as the source IP address of log information.
<Sysname> system-view
[Sysname] interface Vlan-interace1
[Sysname-Vlan-interace1] ip address 2.2.2.2
[Sysname-Vlan-interace1] quit
[Sysname] info-center loghost source Vlan-interace1
After the above configuration, the log information in the following format is displayed on the log host
(compared with the default format, the following format has the -DevIP=2.2.2.2 field):
<188>Jul 22
Vlan-interace1: link status is UP0

info-center monitor channel

Syntax
info-center monitor channel { channel-number | channel-name }
undo info-center monitor channel
06:11:31 2008 Sysname %%10IFNET/4/LINK
16-13
Vlan-interace1: link status
UPDOWN(l):-DevIP=2.2.2.2;