Ntp-Service Unicast-Peer - HP E4510-48G Command Reference Manual

View
System view
Default Level
2: System level
Parameters
interface-type interface-number: Specifies an interface by its interface type and interface number.
Description
Use the ntp-service source-interface command to specify the source interface for NTP messages.
Use the undo ntp-service source-interface command to restore the default.
By default, no source interface is specified for NTP messages, and the system uses the IP address of
the interface determined by the matched route as the source IP address of NTP messages.
If you do not wish the IP address of a certain interface on the local device to become the destination
address of response messages, you can use this command to specify the source interface for NTP
messages, so that the source IP address in NTP messages is the primary IP address of this interface.
Examples
# Specify the source interface of NTP messages as VLAN-interface 1.
<Sysname> system-view
[Sysname] ntp-service source-interface vlan-interface 1

ntp-service unicast-peer

Syntax
ntp-service unicast-peer [ vpn-instance vpn-instance-name ] { ip-address | peer-name }
[ authentication-keyid keyid | priority | source-interface interface-type interface-number | version
number ] *
undo ntp-service unicast-peer [ vpn-instance vpn-instance-name ] { ip-address | peer-name }
View
System view
Default Level
2: System level
Parameters
vpn-instance vpn-instance-name: Specifies a VPN instance by its name, where vpn-instance-name is
a string of 1 to 31 characters.
ip-address: IP address of the symmetric-passive peer. It must be a unicast address, rather than a
broadcast address, a multicast address or the IP address of the local clock.
peer-name: Host name of the symmetric-passive peer, a string of 1 to 20 characters.
authentication-keyid keyid: Specifies the key ID to be used for sending NTP messages to the peer,
where keyid is in the range of 1 to 4294967295.
19-13