Igmp-Snooping Special-Query Source-Ip - HP E4510-48G Command Reference Manual

View
Ethernet port view, port group view
Default Level
2: System level
Parameters
None
Description
Use the igmp-snooping source-deny command to enable multicast source port filtering.
Use the undo igmp-snooping source-deny command to disable multicast source port filtering.
By default, multicast source port filtering is disabled.
This command works on IGMP Snooping–enabled VLANs.
Examples
# Enable source port filtering for multicast data on GigabitEthernet1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet1/0/1
[Sysname-GigabitEthernet1/0/1] igmp-snooping source-deny

igmp-snooping special-query source-ip

Syntax
igmp-snooping special-query source-ip { current-interface | ip-address }
undo igmp-snooping special-query source-ip
View
VLAN view
Default Level
2: System level
Parameters
current-interface: Sets the source address of IGMP group-specific queries to the address of the
current VLAN interface. If the current VLAN interface does not have an IP address, the default IP
address 0.0.0.0 will be used as the source IP address of IGMP group-specific queries.
ip-address: Sets the source address of IGMP group-specific queries to the specified address.
Description
Use the igmp-snooping special-query source-ip command to configure the source IP address of
IGMP group-specific queries.
Use the undo igmp-snooping special-query source-ip command to restore the default
configuration.
By default, the source IP address of IGMP group-specific queries is 0.0.0.0.
1-18