Display Snmp-Agent Group - HP E4510-48G Command Reference Manual

Table 10-1 display snmp-agent community command output description
Field
Community name
Group name
Acl
Storage-type

display snmp-agent group

Syntax
display snmp-agent group [ group-name ]
View
Any view
Default Level
1: Monitor level
Parameters
group-name: Specifies the SNMP group name, a string of 1 to 32 characters, case sensitive.
Description
Use the display snmp-agent group command to display information for the SNMP agent group,
including group name, security model, MIB view, storage type, and so on. Absence of the group-name
parameter indicates that information for all groups will be displayed.
Examples
# Display the information of all SNMP agent groups.
Community name.
If a community name is created by using the snmp-agent
community command, the community name will be displayed.
If a community name is created by using the snmp-agent usm-user
{ v1 | v2c } command, the user name will be displayed.
SNMP group name.
If a community name is created by using the snmp-agent
community command, the group name and the community name
are the same, which means the community name will be displayed.
If a community name is created by using the snmp-agent usm-user
{ v1 | v2c } command, the name of the group to which the user
belongs will be displayed.
The number of the ACL in use.
After an ACL is configured, only the Network Management Station
(NMS) with the IP address that matches the ACL rule can access the
device.
Storage type, which could be:
volatile: Information will be lost if the system is rebooted
nonVolatile: Information will not be lost if the system is rebooted
permanent: Information will not be lost if the system is rebooted.
Modification is permitted, but deletion is forbidden
readOnly: Information will not be lost if the system is rebooted. Read
only, that is, no modification, no deletion
other: Other storage types
10-2
Description