Multicast-Vlan; Port (Multicast Vlan View) - HP E4510-48G Command Reference Manual

multicast-vlan

Syntax
multicast-vlan vlan-id
undo multicast-vlan { all | vlan-id }
View
System view
Default Level
2: System level
Parameters
vlan-id: Specifies a VLAN by its ID, in the range of 1 to 4094.
all: Deletes all multicast VLANs.
Description
Use the multicast-vlan command to configure the specified VLAN as a multicast VLAN and enter
multicast VLAN view.
Use the undo multicast-vlan command to remove the specified VLAN as a multicast VLAN.
The VLAN to be configured is not a multicast VLAN by default.
Note that:
The specified VLAN to be configured as a multicast VLAN must exist.
For a sub-VLAN-based multicast VLAN, you need to enable IGMP Snooping only in the multicast
VLAN; for a port-based multicast VLAN, you need to enable IGMP Snooping in both the multicast
VLAN and all the user VLANs.
Related commands: igmp-snooping enable in the IGMP Snooping Commands in the IP Multicast
Volume.
Examples
# Enable IGMP Snooping in VLAN 100. Configure it as a multicast VLAN and enter multicast VLAN
view.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 100
[Sysname-vlan100] igmp-snooping enable
[Sysname-vlan100] quit
[Sysname] multicast-vlan 100
[Sysname-mvlan-100]

port (multicast VLAN view)

Syntax
port interface-list
2-2