Ip Route-Static Default-Preference - HP E4510-48G Command Reference Manual

Related commands: display ip routing-table, ip route-static default-preference.
To configure track monitoring for an existing static route, simply associate the static route with a
track entry. For a non-existent static route, configure it and associate it with a Track entry.
If a static route needs route recursion, the associated track entry must monitor the nexthop of the
recursive route instead of that of the static route; otherwise, a valid route may be mistakenly
considered invalid.
Examples
# Configure a static route, whose destination address is 1.1.1.1/24, next hop address is 2.2.2.2, tag
value is 45, and description information is for internet & intranet.
<Sysname> system-view
[Sysname] ip route-static 1.1.1.1 24 2.2.2.2 tag 45 description for internet & intranet

ip route-static default-preference

Syntax
ip route-static default-preference default-preference-value
undo ip route-static default-preference
View
System view
Default Level
2: System level
Parameters
default-preference-value: Default preference for static routes, which is in the range of 1 to 255.
Description
Use the ip route-static default-preference command to configure the default preference for static
routes.
Use the undo ip route-static default-preference command to restore the default.
By default, the default preference of static routes is 60.
Note that:
If no preference is specified when configuring a static route, the default preference is used.
When the default preference is re-configured, it applies to newly added static routes only.
Related commands: ip route-static and display ip routing-table in IP Routing Table Display
Commands in the IP Routing Volume.
2-3