Management-Vlan Synchronization Enable - HP E4510-48G Command Reference Manual

Description
Use the management-vlan command to specify the management VLAN.
Use the undo management-vlan command to restore the default.
By default, VLAN 1 is the management VLAN.
Note that:
The management VLAN must be specified before a cluster is created. Once a member device is
added to a cluster, the management VLAN configuration cannot be modified. To modify the
management VLAN for a device belonging to a cluster, you need to cancel the cluster-related
configurations on the device, specify the desired VLAN to be the management VLAN, and then
re-create the cluster.
For the purpose of security, you are not recommended to configure the management VLAN as the
default VLAN ID of the port connecting the management device and the member devices.
Only when the default VLAN ID of all cascade ports and the port connecting the management
device and the member device is the management VLAN, can the packets in the management
VLAN packets be passed without a tag. Otherwise, you must configure the packets from a
management VLAN to pass these ports. For the configuration procedure, refer to VLAN
Configuration in the Access Volume.
Examples
# Specify VLAN 2 as the management VLAN.
<Sysname> system-view
[Sysname] management-vlan 2

management-vlan synchronization enable

Syntax
management-vlan synchronization enable
undo management-vlan synchronization enable
View
Cluster view
Default Level
1: Monitor level
Parameters
None
Description
Use the management-vlan synchronization enable command to enable the management VLAN
auto-negotiation function.
Use the undo management-vlan synchronization enable command to disable the management
VLAN auto-negotiation function.
By default, the management VLAN auto-negotiation function is disabled.
20-42