Igmp-Snooping Last-Member-Query-Interval - HP E4510-48G Command Reference Manual

Description
Use the igmp-snooping host-join command to configure the current port(s) as simulated member
host(s), namely configure the current port as a member host for the specified multicast group or source
and group.
Use the undo igmp-snooping host-join command to remove the current port(s) as simulated
member host(s) for the specified multicast group or source and group.
By default, this function is disabled.
Note that:
This command works on IGMP Snooping–enabled VLANs. The version of IGMP on the simulated
host depends on the version of IGMP Snooping running in the VLAN.
The source-ip source-address option in the command is meaningful only for IGMP Snooping
version 3. If IGMP Snooping version 2 is running, although you can include source-ip
source-address in the command, the simulated host does not respond to a query message.
If configured in Ethernet port view or Layer 2 aggregate port view, this feature takes effect only if
the port belongs to the specified VLAN.
If configured in port group view, this feature takes effect only on those ports in this port group that
belong to the specified VLAN.
Examples
# Configure GIgabitEthernet1/0/1 as a simulated member host in VLAN 2 for multicast source 1.1.1.1
and multicast group 232.1.1.1.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping version 3
[Sysname-vlan2] quit
[Sysname] interface gigabitethernet1/0/1
[Sysname-GigabitEthernet1/0/1] igmp-snooping host-join 232.1.1.1 source-ip 1.1.1.1 vlan 2

igmp-snooping last-member-query-interval

Syntax
igmp-snooping last-member-query-interval interval
undo igmp-snooping last-member-query-interval
View
VLAN view
Default Level
2: System level
Parameters
interval: Interval between IGMP last-member queries, in seconds. The effective range is 1 to 5.
1-13