Cfd Mep Enable - HP E4510-48G Command Reference Manual

View
Ethernet port view
Default level
2: System level
Parameters
mep mep-id: ID of MEP, ranging from 1 to 8191.
service-instance instance-id: Specifies the service instance ID, ranging from 1 to 32767.
inbound: Creates an inward-facing MEP.
outbound: Creates an outward-facing MEP.
Description
Use the cfd mep command to create a MEP on a port.
Use the undo cfd mep command to delete the specified MEP.
By default, no MEP is configured on a device port.
In creating a MEP, the service instance you specified defines the MD and MA that the MEP belongs to.
Examples
# Create inward-facing MEP 3 in service instance 5.
<Sysname> system-view
[Sysname] cfd md test_md level 3
[Sysname] cfd ma test_ma md test_md vlan 100
[Sysname] cfd service-instance 5 md test_md ma test_ma
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] cfd mep 3 service-instance 5 inbound

cfd mep enable

Syntax
cfd mep service-instance instance-id mep mep-id enable
undo cfd mep service-instance instance-id mep mep-id enable
View
Ethernet port view
Default level
2: System level
Parameters
service-instance instance-id: Specifies the service instance ID, ranging from 1 to 32767.
mep mep-id: Specifies the ID of a MEP, ranging from 1 to 8191.
Description
Use the cfd mep enable command to enable the MEP configured on a port.
6-8