ntp-service broadcast-client
Syntax
ntp-service broadcast-client
undo ntp-service broadcast-client
View
Interface view
Default Level
2: System level
Parameters
None
Description
Use the ntp-service broadcast-client command to configure the device to work in the NTP broadcast
client mode and use the current interface to receive NTP broadcast packets.
Use the undo ntp-service broadcast-client command to remove the configuration.
By default, the device does not work in the NTP broadcast client mode.
Examples
# Configure the device to work in the broadcast client mode and receive NTP broadcast messages on
VLAN-interface 1.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ntp-service broadcast-client
ntp-service broadcast-server
Syntax
ntp-service broadcast-server [ authentication-keyid keyid | version number ] *
undo ntp-service broadcast-server
View
Interface view
Default Level
2: System level
Parameters
authentication-keyid keyid: Specifies the key ID to be used for sending broadcast messages to
broadcast clients, where keyid is in the range of 1 to 4294967295. This parameter is not meaningful if
authentication is not required.
version number: Specifies the NTP version, where number is in the range of 1 to 3 and defaults to 3.
19-8