Dldp Unidirectional-Shutdown; Dldp Work-Mode - HP E4510-48G Command Reference Manual

# Reset DLDP state for GigabitEthernet 1/0/50 (assuming that GigabitEthernet 1/0/50 is shut down by
DLDP).
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/50
[Sysname-GigabitEthernet1/0/50] dldp reset
# Reset DLDP state for all the ports in port group 1 shut down by DLDP.
<Sysname> system-view
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member gigabitethernet 1/0/50 to gigabitethernet 1/0/52
[Sysname-port-group-manual-1] dldp reset

dldp unidirectional-shutdown

Syntax
dldp unidirectional-shutdown { auto | manual }
undo dldp unidirectional-shutdown
View
System view
Default Level
2: System level
Parameters
auto: Sets the port shutdown mode as auto mode, where, when a unidirectional link is detected, the
port involved is shut down by DLDP.
manual: Sets the port shutdown mode as manual mode, where, when a unidirectional link is detected,
DLDP prompts you to shut down the involved port instead of doing so automatically.
Description
Use the dldp unidirectional-shutdown command to set the port shutdown mode.
Use the undo dldp unidirectional-shutdown command to restore the default.
By default, the port shutdown mode is auto mode.
Related commands: dldp work-mode.
Examples
# Set the port shutdown mode as auto mode.
<Sysname> system-view
[Sysname] dldp unidirectional-shutdown auto

dldp work-mode

Syntax
dldp work-mode { enhance | normal }
undo dldp work-mode
4-8