HP E4510-48G Command Reference Manual page 1193

channel-name: Specifies a channel name, which could be a default name or a self-defined name. The
user needs to specify a channel name first before using it as a self-defined channel name. For more
information, refer to the info-center channel name command.
Description
Use the info-center source command to specify the output rules of the system information.
Use the undo info-center source command to remove the specified output rules.
By default, the output rules for the system information are listed in
This command can be used to set the filter and redirection rules of log, trap and debugging
information.
For example, the user can set to output log information with severity higher than warning to the log
host, and information with severity higher than informational to the log buffer. The user can also set to
output trap information of the IP module to a specified output destination.
Note that:
If you do not use the module-name argument to set output rules for a module, the module uses the
default output rules or the output rules set by the default keyword; otherwise the module uses the
output rules separately set for it.
If you use the default keyword to set the output rules for all the modules without specifying the
debug, log, and trap keywords, the default output rules for the modules are used. Refer to
16-8 for details.
If you use the module-name argument to set the output rules for a module without specifying the
debug, log, and trap keywords, the default output rules for the module are as follows: the output
of log and trap information is enabled, with severity being informational; the output of debugging
information is disabled, with severity being debug. For example, if you execute the command
info-center source snmp channel 5, the command is actually equal to the command
info-center source snmp channel 5 debug level debugging state off log level informational
state on trap level informational state on.
If you repeatedly use the command to set the output rules for a module or for all the modules with
the default keyword, the last configured output rules take effect
After you separately set the output rules for a module, you must use the module-name argument
to modify or remove the rules. The new configuration by using the default keyword is invalid on
the module.
You can configure to output the log, trap and debugging information to the trap buffer, but the trap
buffer only receives the trap information and discards the log and debugging information.
You can configure to output the log, trap and debugging information to the log buffer, but the log
buffer only receives the log and debugging information and discards the trap information.
You can configure to output the log, trap and debugging information to the SNMP module, but the
SNMP module only receives the trap information and discards the log and debugging information.
Table 16-8 Default output rules for different output destinations
Output
Modules
destinati
allowed
on
default
Console (all
modules)
LOG
Enabled/
Severity
disabled
Enabled Warning
16-16
Table 16-8.
TRAP
Enabled/
Severity
disabled
Enabled Debug
Table
DEBUG
Enabled/
Severity
disabled
Enabled Debug