Mld-Snooping Fast-Leave; Mld-Snooping General-Query Source-Ip - HP E4510-48G Command Reference Manual

mld-snooping fast-leave

Syntax
mld-snooping fast-leave [ vlan vlan-list ]
undo mld-snooping fast-leave [ vlan vlan-list ]
View
Ethernet port view, Layer 2 aggregate port view, port group view
Default Level
2: System level
Parameters
vlan vlan-list: Defines one or multiple VLANs. You can provide up to 10 VLAN lists, by each of which
you can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id
to end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of
a VLAN ID is 1 to 4094.
Description
Use the mld-snooping fast-leave command to enable fast leave processing on the current port or
group of ports. With this function enabled, when the switch receives an MLD leave message on a port,
it directly removes that port from the forwarding table entry for the specific group.
Use the undo mld-snooping fast-leave command to disable fast leave processing on the current port
or group of ports.
By default, fast leave processing is disabled.
Note that:
This command works on MLD Snooping–enabled VLANs.
If you do not specify any VLAN when using this command in Ethernet port view or Layer 2
aggregate port view, the command will take effect for all VLANs the port belongs to; if you specify
a VLAN or multiple VLANs, the command will take effect only if the port belongs to the specified
VLAN(s).
If you do not specify any VLAN when using this command in port group view, the command will
take effect on all the ports in this group; if you specify a VLAN or multiple VLANs, the command
will take effect only on those ports in this group that belong to the specified VLAN(s).
Related commands: fast-leave.
Examples
# Enable fast leave processing on GigabitEthernet 1/0/1 in VLAN 2.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mld-snooping fast-leave vlan 2

mld-snooping general-query source-ip

Syntax
mld-snooping general-query source-ip { current-interface | ipv6-address }
3-9