Ntp-Service In-Interface Disable; Ntp-Service Max-Dynamic-Sessions - HP E4510-48G Command Reference Manual

Description
Use the ntp-service broadcast-server command to configure the device to work in the NTP
broadcast server mode and use the current interface to send NTP broadcast packets.
Use the undo ntp-service broadcast-server command to remove the configuration.
By default, the device does not work in the NTP broadcast server mode.
Examples
# Configure the device to work in the broadcast server mode and send NTP broadcast messages on
VLAN-interface 1, using key 4 for encryption, and set the NTP version to 3.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ntp-service broadcast-server authentication-keyid 4 version 3

ntp-service in-interface disable

Syntax
ntp-service in-interface disable
undo ntp-service in-interface disable
View
Interface view
Default Level
2: System level
Parameters
None
Description
Use the ntp-service in-interface disable command to disable an interface from receiving NTP
messages.
Use the undo ntp-service in-interface disable command to restore the default.
By default, all interfaces are enabled to receive NTP messages.
Examples
# Disable VLAN-interface 1 from receiving NTP messages.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ntp-service in-interface disable

ntp-service max-dynamic-sessions

Syntax
ntp-service max-dynamic-sessions number
undo ntp-service max-dynamic-sessions
19-9