Ripng Metricin - HP E4510-48G Command Reference Manual

Default Level
2: System level
Parameters
process-id: RIPng process ID, in the range of 1 to 65535.
Description
Use the ripng enable command to enable RIPng on the specified interface.
Use the undo ripng enable command to disable RIPng on the specified interface.
By default, RIPng is disabled on an interface.
Examples
# Enable RIPng100 on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ripng 100 enable

ripng metricin

Syntax
ripng metricin value
undo ripng metricin
View
Interface view
Default Level
2: System level
Parameters
value: Additional metric for received routes, in the range of 0 to 16.
Description
Use the ripng metricin command to specify an additional metric for received RIPng routes.
Use the undo ripng metricin command to restore the default.
By default, the additional metric to received routes is 0.
Related commands: ripng metricout.
Examples
# Specify the additional routing metric as 12 for RIPng routes received by VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ripng metricin 12
5-12