Mld-Snooping Version; Overflow-Replace (Mld-Snooping View) - HP E4510-48G Command Reference Manual

Examples
# Enable the static router port function on GigabitEthernet 1/0/1 in VLAN 2.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname- GigabitEthernet 1/0/1] mld-snooping static-router-port vlan 2

mld-snooping version

Syntax
mld-snooping version version-number
undo mld-snooping version
View
VLAN view
Default Level
2: System level
Parameters
version-number: MLD snooping version, in the range of 1 to 2.
Description
Use the mld-snooping version command to configure the MLD Snooping version.
Use the undo mld-snooping version command to restore the default setting.
By default, the MLD version is 1.
Note that:
This command can take effect only if MLD Snooping is enabled in the VLAN.
This command does not take effect in a sub-VLAN of an IPv6 multicast VLAN.
Related commands: mld-snooping enable; subvlan in IPv6 Multicast VLAN Commands in the IP
Multicast Volume.
Examples
# Enable MLD Snooping in VLAN 2, and set the MLD Snooping version to version 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping version 2

overflow-replace (MLD-Snooping view)

Syntax
overflow-replace [ vlan vlan-list ]
undo overflow-replace [ vlan vlan-list ]
3-22