Dldp Interval - HP E4510-48G Command Reference Manual

Default Level
2: System level
Parameters
None
Description
Use the dldp enable command to enable DLDP.
Use the undo dldp enable command to disable DLDP.
By default, DLDP is disabled both globally and on each port.
Note that:
When executed in system view, these two commands enables/disables DLDP globally; when
executed in Ethernet port view, these two commands enables/disables DLDP on the current
port; when executed in port group view, these two commands enables/disables DLDP on all
the ports in the port group.
These two commands are applicable to Layer 2 Ethernet ports, including optical ports and
electrical ports.
DLDP can take effect only when it is enabled both globally and on a port.
Examples
# Enable DLDP globally, and then enable DLDP on GigabitEthernet 1/0/50.
<Sysname> system-view
[Sysname] dldp enable
[Sysname] interface gigabitethernet 1/0/50
[Sysname-GigabitEthernet1/0/50] dldp enable
# Enable DLDP globally, and then enable DLDP for all the ports in port group 1.
<Sysname> system-view
[Sysname] dldp enable
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member gigabitethernet 1/0/50 to gigabitethernet 1/0/52
[Sysname-port-group-manual-1] dldp enable

dldp interval

Syntax
dldp interval time
undo dldp interval
View
System view
Default Level
2: System level
4-6