Igmp-Snooping Static-Router-Port - HP E4510-48G Command Reference Manual

<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping version 3
[Sysname-vlan2] quit
[Sysname] interface gigabitethernet1/0/1
[Sysname-GigabitEthernet1/0/1] igmp-snooping static-group 232.1.1.1 source-ip 1.1.1.1 vlan
2

igmp-snooping static-router-port

Syntax
igmp-snooping static-router-port vlan vlan-id
undo igmp-snooping static-router-port vlan vlan-id
View
Ethernet port view, Layer 2 aggregate port view, port group view
Default Level
2: System level
Parameters
vlan vlan-id: Specifies a VLAN in which one or more static router ports are to be configured, where
vlan-id is in the range of 1 to 4094.
Description
Use the igmp-snooping static-router-port command to configure the current port(s) as static router
port(s).
Use the undo igmp-snooping static-router-port command to restore the system default.
By default, no ports are static router ports.
Note that:
This command works on IGMP Snooping–enabled VLANs.
This command does not take effect in a sub-VLAN of a multicast VLAN.
If configured in Ethernet port view or Layer 2 aggregate port view, this feature takes effect only if
the port belongs to the specified VLAN.
If configured in port group view, this feature takes effect only on those ports in this port group that
belong to the specified VLAN.
Related commands: subvlan in Multicast VLAN Commands in the IP Multicast Volume.
Examples
# Enable the static router port function on GigabitEthernet1/0/1 in VLAN 2.
<Sysname> system-view
[Sysname] interface gigabitethernet1/0/1
[Sysname-GigabitEthernet1/0/1] igmp-snooping static-router-port vlan 2
1-20