Port (Ipv6 Multicast Vlan View); Port Multicast-Vlan Ipv6 - HP E4510-48G Command Reference Manual

port (IPv6 multicast VLAN view)

Syntax
port interface-list
undo port { all | interface-list }
View
IPv6 multicast VLAN view
Default Level
2: System level
Parameters
interface-list: Specifies a port in the form of interface-type interface-number, or a port range in the form
of interface-type start-interface-number to interface-type end-interface-number, where the end
interface number must be greater than the start interface number.
all: Deletes all the ports in the current IPv6 multicast VLAN.
Description
Use the port command to assign port(s) to the current IPv6 multicast VLAN.
Use the undo port command to delete port(s) from the current IPv6 multicast VLAN.
By default, an IPv6 multicast VLAN has no ports.
Note that:
A port can belong to only one IPv6 multicast VLAN.
Only the following types of ports can be configured as IPv6 multicast VLAN ports: Ethernet, and
Layer 2 aggregate ports.
Examples
# Assign ports GigabitEthernet1/0/1 through GigabitEthernet1/0/5 to IPv6 multicast VLAN 100.
<Sysname> system-view
[Sysname] multicast-vlan ipv6 100
[Sysname-ipv6-mvlan-100] port gigabitethernet1/0/1 to gigabitethernet1/0/5

port multicast-vlan ipv6

Syntax
port multicast-vlan ipv6 vlan-id
undo port multicast-vlan ipv6
View
Ethernet port view, Layer 2 aggregate port view, port group view.
Default Level
2: System level
4-3