Mld-Snooping Group-Policy - HP E4510-48G Command Reference Manual

to end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of
a VLAN ID is 1 to 4094.
Description
Use the mld-snooping group-limit command to configure the maximum number of IPv6 multicast
groups that can be joined on a port.
Use the undo mld-snooping group-limit command to restore the default setting.
By default, maximum number of IPv6 multicast groups that can be joined on a port is 1000.
Note that:
If you do not specify any VLAN when using this command in Ethernet port view or Layer 2
aggregate port view, the command will take effect for all VLANs the port belongs to; if you specify
a VLAN or multiple VLANs, the command will take effect only if the port belongs to the specified
VLAN(s).
If you do not specify any VLAN when using this command in port group view, the command will
take effect on all the ports in this group; if you specify a VLAN or multiple VLANs, the command
will take effect only on those ports in this group that belong to the specified VLAN(s).
Examples
# Specify to allow a maximum of 10 IPv6 multicast groups to be joined on GigabitEthernet 1/0/1 in
VLAN 2.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet 1/0/1] mld-snooping group-limit 10 vlan 2

mld-snooping group-policy

Syntax
mld-snooping group-policy acl6-number [ vlan vlan-list ]
undo mld-snooping group-policy [ vlan vlan-list ]
View
Ethernet port view, Layer 2 aggregate port view, port group view
Default Level
2: System level
Parameters
acl6-number: Basic or advanced IPv6 ACL number, in the range of 2000 to 3999. The IPv6 source
address or address range specified in the advanced IPv6 ACL rule is the IPv6 multicast source
address(es) specified in MLDv2 reports, rather than the source address in the IPv6 packets. The
system assumes that an MLDv1 report or an MLDv2 IS_EX or TO_EX report that does not carry an
IPv6 multicast source address carries an IPv6 multicast source address of 0::0.
vlan vlan-list: Defines one or multiple VLANs. You can provide up to 10 VLAN lists, by each of which
you can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id
to end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of
a VLAN ID is 1 to 4094.
3-11