Mld-Snooping Group-Limit - HP E4510-48G Command Reference Manual

undo mld-snooping general-query source-ip
View
VLAN view
Default Level
2: System level
Parameters
current-interface: Sets the source IPv6 link-local address of MLD general queries to the IPv6 address
of the current VLAN interface. If the current VLAN interface does not have an IPv6 address, the default
IPv6 address FE80::02FF:FFFF:FE00:0001 will be used as the source IPv6 address of MLD general
queries.
ipv6-address: Specifies the source IPv6 address of MLD general queries, which can be any legal IPv6
link-local address.
Description
Use the mld-snooping general-query source-ip command to configure the source IPv6 address of
MLD general queries.
Use the undo mld-snooping general-query source-ip command to restore the default configuration.
By default, the source IPv6 address of MLD general queries is FE80::02FF:FFFF:FE00:0001.
This command takes effect only if MLD Snooping is enabled in the VLAN.
Examples
# In VLAN 2, specify FE80:0:0:1::1 as the source IPv6 address of MLD general queries.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping general-query source-ip fe80:0:0:1::1

mld-snooping group-limit

Syntax
mld-snooping group-limit limit [ vlan vlan-list ]
undo mld-snooping group-limit [ vlan vlan-list ]
View
Ethernet port view, Layer 2 aggregate port view, port group view
Default Level
2: System level
Parameters
limit: Maximum number of IPv6 multicast groups that can be joined on a port. The value is in the range
1 to 1000.
vlan vlan-list: Defines one or multiple VLANs. You can provide up to 10 VLAN lists, by each of which
you can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id
3-10