Patch Run - HP E4510-48G Command Reference Manual

Note that the patch install command changes the patch file location specified with the patch location
command to the directory specified by the patch-location argument of the patch install command. For
example, if you execute the patch location xxx command and then the patch install yyy command,
the patch file location automatically changes from xxx to yyy.
Examples
# Configure the root directory of the flash as the patch file location.
<Sysname> system-view
[Sysname] patch location flash:

patch run

Syntax
patch run patch-number [ slot slot-number ]
View
System view
Default Level
3: Manage level
Parameters
patch-number: Sequence number of a patch. The valid values of this argument depend on the patch
file used.
slot slot-number: Specifies a member device by its member ID. The value range of this argument
varies with the device model and can be displayed through the display irf command.
Description
Use the patch run command to confirm the running of the specified patch and all the ACTIVE patches
before the specified patch number.
With the slot keyword specified, the command confirms the running state of all the qualified patches
on a member device. If the keyword is not specified, the command confirms the running state of all the
qualified patches on all the member devices.
This command is applicable to patches in the ACTIVE state only.
If the running of a patch is confirmed, after the system reboots, the patch will still be effective.
Examples
# Confirm the running of patch 3 and all the ACTIVE patches before patch 3 on the device with
member ID being 1.
<Sysname> system-view
[Sysname] patch run 3 slot 1
17-6