Display Rrpp Ring-Group - HP E4510-48G Command Reference Manual

Table 3-1 display rrpp brief command output description
Field
Flags for Node Mode
RRPP Protocol Status
Number of RRPP Domains
Domain ID
Control VLAN
Protected VLAN
Hello Timer
Fail Timer
Ring ID
Ring Level
Node Mode
Primary/Common Port
Secondary/Edge Port
Enable Status

display rrpp ring-group

Syntax
display rrpp ring-group [ ring-group-id ]
View
Any view
RRPP node mode
M represents master node
T represents transit node
E represents edge node
A represents assistant edge node
RRPP protocol status
Enable (globally enabled)
Disable (globally disabled)
Number of RRPP domains configured
RRPP domain ID
Control VLANs of the RRPP domain: Major and Sub
List of VLANs protected by the RRPP domain. MSTIs are displayed
here. To get the VLANs corresponding to these MSTIs, use the
display stp region-configuration command.
Hello Timer value in seconds
Fail Timer value in seconds
RRPP ring ID
RRPP ring level
0 representing primary ring
1 representing subring
Node mode
Primary port when the node mode is master node or transit node
Common port when the node mode is edge node or assistant
edge node
"-" appears when the port is not configured on the ring or the
board to which the port belongs does not start
Secondary port when the node mode is master node or transit
node
Edge port when the node mode is edge node or assistant edge
node
"-" appears when the port is not configured on the ring or the
board to which the port belongs does not start
RRPP ring status
Yes indicates enabled
No indicates disabled
3-3
Description