Info-Center Loghost Source - HP E4510-48G Command Reference Manual

View
System view
Default Level
2: System level
Parameters
host-ip: The IP address of the log host.
channel: Specifies the channel through which system information can be output to the log host.
channel-number: Specifies a channel number, in the range 0 to 9.
channel-name: Specifies a channel name, which could be a default name or a self-defined name. The
user needs to specify a channel name first before using it as a self-defined channel name. For more
information, refer to the info-center channel name command.
facility local-number: The logging facility of the log host. The value can be local0 to local7 and defaults
to local7. Logging facility is mainly used to mark different logging sources, query and filer the logs of
the corresponding log source.
Description
Use the info-center loghost command to specify a log host and to configure the related parameters.
Use the undo info-center loghost command to restore the default configurations on a log host.
By default, output of system information to the log host is disabled. When it is enabled, the default
channel name will be loghost and the default channel number will be 2.
Note that:
The info-center loghost command takes effect only after the information center is enabled with
the info-center enable command.
Ensure to input a correct IP address while using the info-center loghost command to configure
the IP address for a log host. System will prompt an invalid address if the loopback address
(127.0.0.1) is input.
A maximum number of 4 hosts (different) can be designated as the log host.
Examples
# Output log information to a Unix station with the IP address being 1.1.1.1/16.
<Sysname> system-view
[Sysname] info-center loghost 1.1.1.1

info-center loghost source

Syntax
info-center loghost source interface-type interface-number
undo info-center loghost source
View
System view
16-12