HP E4510-48G Command Reference Manual page 566

Field
dscp dscp-list
destination-mac
mac-address
ip-precedence
ip-precedence-list
protocol protocol-name
service-dot1p 8021p-list
service-vlan-id vlan-id-list
source-mac mac-address
Description
Use the if-match command to define a rule to match a specific type of packets.
Use the undo if-match command to remove a matching rule.
Specifies to match packets by DSCP precedence. The dscp-list
argument is a list of DSCP values in the range of 0 to 63 or keywords
shown in Table 1-4.
Even though you can provide up to eight space-separated DSCP
values for this argument, the Switch 4510G series switches support
only one DSCP value in a rule. If you configure multiple DSCP
values in a rule, the rule cannot be issued.
Specifies to match the packets with a specified destination MAC
address.
Specifies to match packets by IP precedence. The ip-precedence-list
argument is a list of IP precedence values in the range of 0 to 7.
Even though you can provide up to eight space-separated IP
precedence values for this argument, the Switch 4510G series
switches support only one IP precedence value in a rule. If you
configure multiple IP precedence values in a rule, the rule cannot be
issued.
Specifies to match the packets of a specified protocol. The
protocol-name argument can be IP or IPv6.
Specifies to match packets by 802.1p precedence of the service
provider network. The 8021p-list argument is a list of CoS values in
the range of 0 to 7.
Even though you can provide up to eight space-separated CoS
values for this argument, the Switch 4510G series switches support
only one CoS value in a rule. If you configure multiple CoS values in
a rule, the rule cannot be issued.
Specifies to match the packets of specified VLANs of the operator's
network. The vlan-id-list argument is a list of VLAN IDs, in the form of
vlan-id to vlan-id or multiple discontinuous VLAN IDs (separated by
space). You can specify up to eight VLAN IDs for this argument at a
time. VLAN ID is in the range 1 to 4094.
In a class configured with the operator and, the logical relationship
between the service VLAN IDs specified for the service-vlan-id
keyword is or.
Specifies to match the packets with a specified source MAC address.
1-3
Description