Ntp-Service Multicast-Server - HP E4510-48G Command Reference Manual

4510g series
Table of Contents

Advertisement

Parameters
ip-address: Multicast IP address, defaulting to 224.0.1.1.
Description
Use the ntp-service multicast-client command to configure the device to work in the NTP multicast
client mode and use the current interface to receive NTP multicast packets.
Use the undo ntp-service multicast-client command to remove the configuration.
By default, the device does not work in the NTP multicast client mode.
Examples
# Configure the device to work in the multicast client mode and receive NTP multicast messages on
VLAN-interface 1, and set the multicast address to 224.0.1.1.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ntp-service multicast-client 224.0.1.1

ntp-service multicast-server

Syntax
ntp-service multicast-server [ ip-address ] [ authentication-keyid keyid | ttl ttl-number | version
number ] *
undo ntp-service multicast-server [ ip-address ]
View
Interface view
Default Level
2: System level
Parameters
ip-address: Multicast IP address, defaulting to 224.0.1.1.
authentication-keyid keyid: Specifies the key ID to be used for sending multicast messages to
multicast clients, where keyid is in the range of 1 to 4294967295. This parameter is not meaningful if
authentication is not required.
ttl ttl-number: Specifies the TTL of NTP multicast messages, where ttl-number is in the range of 1 to
255 and defaults to 16.
version number: Specifies the NTP version, where number is in the range of 1 to 3 and defaults to 3.
Description
Use the ntp-service multicast-server command to configure the device to work in the NTP multicast
server mode and use the current interface to send NTP multicast packets.
Use the undo ntp-service multicast-server command to remove the configuration.
By default, the device does not work in the NTP multicast server mode.
19-11

Advertisement

Table of Contents
loading

Table of Contents