Irf Member Irf-Port - HP E4510-48G Command Reference Manual

irf member irf-port

Syntax
irf member member-id irf-port irf-port-id port port-list
undo irf member member-id irf - port irf-port-id
View
System view
Default Level
3: Manage level
Parameters
member-id: ID of the IRF member, in the range 1 to 4. With this argument, you can configure the IRF
ports of another IRF member on this device. You can view the member IDs of in IRF by using the
display irf command.
irf-port-id: ID of an enabled IRF port, the value can be either 1 (the left port) or 2 (the right port).
port-list: Physical IRF port list. The port-list is in the format of { port }&<1-4>, where
port indicates the port ID. The physical IRF ports are numbered according to their physical
locations on the rear panel of the Switch 4510G series. With the rear panel facing you, the
physical IRF ports are numbered successively from left to right: ports on the interface module in
slot 1 are numbered 1 and 2, and ports on the interface module in slot 2 are numbered 3 and 4.
&<1-4> indicates that you can specify one to four ports at one time. When multiple ports are
specified, they aggregate together to form an IRF port. On the Switch 4510G series, only the
physical IRF ports that are on the same interface module can be aggregated together.
For the correspondence between an IRF port and physical IRF port, refer to the related part in IRF
Configuration.
Description
Use the irf member irf-port command to bind the physical IRF port(s) to an IRF port of a device, and
enable IRF on the IRF port simultaneously.
Use the undo irf member irf-port command to disable IRF on an IRF port. If this IRF port is
aggregated from multiple physical IRF ports, the aggregated physical ports are disaggregated.
Note the following:
The above configuration takes effect after the reboot of the device.
An IRF port should be enabled first before it can connect to other devices to form an IRF.
Examples
# Bind physical IRF port 1 to IRF port 1, and enable IRF port 1 of the local device.
21-11