Cluster-Mac Syn-Interval - HP E4510-48G Command Reference Manual

Default Level
2: System level
Parameters
mac-address: Multicast MAC address (in hexadecimal in the format of H-H-H), which can be
0180-c200-0000, 0180-c200-000a, 0180-c200-0020 through 0180-c200-002f, or 010f-e200-0002.
Description
Use the cluster-mac command to configure the destination MAC address for cluster management
protocol packets.
Use the undo cluster-mac command to restore the default.
By default, the destination MAC address is 0180-c200-000a.
Note that this command can be executed on the management device only.
Examples
# Set the multicast MAC address of the cluster management protocol packets to 0180-c200-0000.
<Sysname> system-view
[Sysname] cluster
[Sysname-cluster] ip-pool 10.1.1.1 24
[Sysname-cluster] build aaa
[aaa_0.Sysname-cluster] cluster-mac 0180-c200-0000

cluster-mac syn-interval

Syntax
cluster-mac syn-interval interval-time
View
Cluster view
Default Level
2: System level
Parameters
interval-time: Interval (in minutes) to send broadcast packets, in the range 0 to 30. If the interval is set
to 0, the management device does not send broadcast packets to the member devices.
Description
Use the cluster-mac syn-interval command to set the interval for a management device to send MAC
address negotiation broadcast packets for cluster management.
By default, the interval is set to one minute.
Note that this command can be executed on the management device only.
Examples
# Set the interval for the management device to send MAC address negotiation broadcast packets for
cluster management to two minutes.
20-23