Report-Aggregation (Mld-Snooping View) - HP E4510-48G Command Reference Manual

View
MLD-Snooping view
Default Level
2: System level
Parameters
vlan vlan-list: Defines one or multiple VLANs. You can provide up to 10 VLAN lists, by each of which
you can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id
to end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of
a VLAN ID is 1 to 4094.
Description
Use the overflow-replace command to enable the IPv6 multicast group replacement function globally.
Use the undo overflow-replace command to disable the IPv6 multicast group replacement function
globally.
By default, the IPv6 multicast group replacement function is disabled globally.
Note that:
This command works on MLD Snooping–enabled VLANs.
If you do not specify any VLAN, the command will take effect for all VLANs; if you specify a VLAN
or multiple VLANs, the command will take effect for the specified VLAN(s) only.
Related commands: mld-snooping overflow-replace.
Examples
# Enable the IPv6 multicast group replacement function globally in VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] overflow-replace vlan 2

report-aggregation (MLD-Snooping view)

Syntax
report-aggregation
undo report-aggregation
View
MLD-Snooping view
Default Level
2: System level
Parameters
None
3-23