HP E4510-48G Command Reference Manual page 1331

Default Level
1: Monitor level
Parameters
node node-id: Displays the IPC performance statistics information of the specified node, where
node-id represents the number of the specified node, in the range of 0 to 9.
self-node: Displays the IPC performance statistics information of the local node.
channel channel-id: Displays the IPC performance statistics information of the specified channel,
where channel-id represents the channel number, in the range of 0 to 159.
Description
Use the display ipc performance command to display IPC performance statistics information.
If IPC performance statistics is enabled, the command displays the current IPC performance statistics;
if IPC performance statistics is disabled, the command displays the IPC performance statistics at the
time when IPC performance statistics is disabled.
Related commands: ipc performance enable.
Examples
# Display IPC performance statistics information of node 6.
<Sysname> display ipc performance node 6
Peak: Peak rate (pps)
10Sec: Average rate in the last 10 seconds (pps)
1Min: Average rate in the last 1 minute (pps)
5Min: Average rate in the last 5 minutes (pps)
Total-Data: Total number of data (packets)
Statistics for packets sent successfully:
Peak 10Sec
------------------------------------------------------------
1 1
Statistics for packets recieved successfully:
Peak 10Sec
------------------------------------------------------------
1 1
Statistics for packets acknowledged:
Peak 10Sec
------------------------------------------------------------
1 1
Table 22-6 display ipc performance command output description
Field
Peak
10Sec
1Min
1Min 5Min
1 0
1Min 5Min
1 0
1Min 5Min
1 0
Peak rate (average rate is counted every 10 seconds, the greatest
value of which is taken as the peak rate), in pps
Average rate in the past 10 seconds, in pps
Average rate in the past 1 minute, in pps
22-6
Total-Data
80
Total-Data
82
Total-Data
78
Description