Secondary Accounting (Hwtacacs Scheme View); Secondary Authentication (Hwtacacs Scheme View) - HP E4510-48G Command Reference Manual

secondary accounting (HWTACACS scheme view)

Syntax
secondary accounting ip-address [ port-number ]
undo secondary accounting
View
HWTACACS scheme view
Default Level
2: System level
Parameters
ip-address: IP address of the server, a valid unicast address in dotted decimal notation. The default is
0.0.0.0.
port-number: Port number of the server. It ranges from 1 to 65535 and defaults to 49.
Description
Use the secondary accounting command to specify the secondary HWTACACS accounting server.
Use the undo secondary accounting command to remove the configuration.
By default, no secondary HWTACACS accounting server is specified.
Note that:
The IP addresses of the primary and secondary accounting servers cannot be the same.
Otherwise, the configuration fails.
The HWTACACS service port configured on the device and that of the HWTACACS server must
be consistent.
If you configure the command for more than one time, the last configuration takes effect.
You can remove an accounting server only when no active TCP connection for sending
accounting packets is using it.
Examples
# Specify the secondary accounting server.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] secondary accounting 10.163.155.12 49

secondary authentication (HWTACACS scheme view)

Syntax
secondary authentication ip-address [ port-number ]
undo secondary authentication
View
HWTACACS scheme view
3-12