HP E4510-48G Command Reference Manual page 879

Field
Protected VLAN
Hello Timer
Fail Timer
Ring ID
Ring Level
Node Mode
Ring State
Enable Status
Active Status
Primary Port
Secondary Port
Common Port
Edge Port
Port status
List of VLANs protected by the RRPP domain. MSTIs are displayed
here. To get the VLANs corresponding to these MSTIs, use the
display stp region-configuration command.
Hello Timer value in seconds
Fail Timer value in seconds
RRPP ring ID
RRPP ring level:
0 representing primary ring
1 representing subring
Node mode:
Master node
Transit node
Edge node
Assistant edge node
RRPP ring state. This field makes sense only when the node mode
field is master node.
"Complete" appears when the ring is in health state;
"Failed" appears when the ring is in disconnect sate;
"–" appears in all the other cases.
RRPP ring enable status
Yes for enabled
No for disabled
RRPP ring activation status. An RRPP ring can be active only when
the RRPP protocol and the RRPP ring are both enabled. Therefore,
you can also use this field to identify whether the RRPP protocol are
enabled. Two statuses are available:
Yes for active
No for inactive
The primary port field means the node mode is master node or
transit node. "-" appears when the port is not configured on the ring
or the board to which the port belongs does not start.
The secondary port field means the node mode is master node or
transit node. - appears when the port is not configured on the ring or
the board to which the port belongs does not start.
The common port field means the node mode is edge node or
assistant edge node. "-" appears when the port is not configured on
the ring or the board to which the port belongs does not start.
The edge port field means the node mode is edge node or assistant
edge node. "-" appears when the port is not configured on the ring
or the board to which the port belongs does not start.
Port status includes down, up and blocked; "-" appears in one of the
following cases:
the ring is inactive
the port is not configured on the ring
the board to which the port belongs does not start
3-9
Description