Igmp-Snooping Max-Response-Time - HP E4510-48G Command Reference Manual

Description
Use the igmp-snooping last-member-query-interval command to configure the interval between
IGMP last-member queries in the VLAN.
Use the undo igmp-snooping last-member-query-interval command to restore the default setting.
By default, the IGMP last-member query interval is 1 second.
This command takes effect only if IGMP Snooping is enabled in the VLAN.
Related commands: last-member-query-interval.
Examples
# Set the interval between IGMP last-member queries to 3 seconds in VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping last-member-query-interval 3

igmp-snooping max-response-time

Syntax
igmp-snooping max-response-time interval
undo igmp-snooping max-response-time
View
VLAN view
Default Level
2: System level
Parameters
interval: Maximum response time to IGMP general queries, in seconds. The effective range is 1 to 25.
Description
Use the igmp-snooping max-response-time command to configure the maximum response time to
IGMP general queries in the VLAN.
Use the undo igmp-snooping max-response-time command to restore the default setting.
By default, the maximum response time to IGMP general queries is 10 seconds.
This command takes effect only if IGMP Snooping is enabled in the VLAN.
Related commands: max-response-time, igmp-snooping query-interval.
Examples
# Set the maximum response time to IGMP general queries to 5 seconds in VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping max-response-time 5
1-14