HP E4510-48G Command Reference Manual page 668

By default, no security policy server is specified.
Note that:
You can specify up to eight security policy servers for a RADIUS scheme.
You can use the commands to change the settings only when no user is using the RADIUS
scheme.
Related commands: radius nas-ip.
Examples
# For RADIUS scheme radius1, set the IP address of a security policy server to 10.110.1.2.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] security-policy-server 10.110.1.2
server-type
Syntax
server-type { extended | standard }
undo server-type
View
RADIUS scheme view
Default Level
2: System level
Parameters
extended: Specifies the extended RADIUS server (generally iMC), which requires the RADIUS client
and RADIUS server to interact according to the procedures and packet formats provisioned by the
private RADIUS protocol.
standard: Specifies the standard RADIUS server, which requires the RADIUS client end and RADIUS
server to interact according to the regulation and packet format of the standard RADIUS protocol (RFC
2865/2866 or newer).
Description
Use the server-type command to specify the RADIUS server type supported by the device.
Use the undo server-type command to restore the default.
By default, the supported RADIUS server type is standard.
Note that you can use the commands to change the setting only when no user is using the RADIUS
scheme.
Related commands: radius scheme.
Examples
# Set the RADIUS server type of RADIUS scheme radius1 to standard.
<Sysname> system-view
[Sysname] radius scheme radius1
2-21