Primary Accounting (Radius Scheme View) - HP E4510-48G Command Reference Manual

undo nas-ip
View
RADIUS scheme view
Default Level
2: System level
Parameters
ip-address: IP address in dotted decimal notation. It must be an address of the device and cannot be
all 0s address, all 1s address, a class D address, a class E address or a loopback address.
Description
Use the nas-ip command to set the IP address for the device to use as the source address of the
RADIUS packets to be sent to the server.
Use the undo nas-ip command to remove the configuration.
By default, the source IP address of a packet sent to the server is that configured by the radius nas-ip
command in system view.
Note that:
Specifying a source address for the RADIUS packets to be sent to the server can avoid the
situation where the packets sent back by the RADIUS server cannot reach the device as the result
of a physical interface failure. The address of a loopback interface is recommended.
The nas-ip command in RADIUS scheme view is only for the current RADIUS scheme, while the
radius nas-ip command in system view is for all RADIUS schemes. However, the nas-ip
command in RADIUS scheme view overwrites the configuration of the radius nas-ip command.
You can use the commands to change the settings only when no user is using the RADIUS
scheme.
Related commands: radius nas-ip.
Examples
# Set the IP address for the device to use as the source address of the RADIUS packets to 10.1.1.1.
<Sysname> system-view
[Sysname] radius scheme test1
[Sysname-radius-test1] nas-ip 10.1.1.1

primary accounting (RADIUS scheme view)

Syntax
primary accounting ip-address [ port-number ]
undo primary accounting
View
RADIUS scheme view
Default Level
2: System level
2-9