Igmp-Snooping Host-Join - HP E4510-48G Command Reference Manual

undo igmp-snooping host-aging-time
View
VLAN view
Default Level
2: System level
Parameters
interval: Dynamic member port aging time, in seconds. The effective range is 200 to 1,000.
Description
Use the igmp-snooping host-aging-time command to configure the aging time of dynamic member
ports in the current VLAN.
Use the undo igmp-snooping host-aging-time command to restore the default setting.
By default, the aging time of dynamic member ports is 260 seconds.
This command takes effect only if IGMP Snooping is enabled in the VLAN.
Related commands: host-aging-time.
Examples
# Set the aging time of dynamic member ports to 300 seconds in VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping host-aging-time 300

igmp-snooping host-join

Syntax
igmp-snooping host-join group-address [ source-ip source-address ] vlan vlan-id
undo igmp-snooping host-join group-address [ source-ip source-address ] vlan vlan-id
View
Ethernet port view, Layer 2 aggregate port view, port group view
Default Level
2: System level
Parameters
group-address: Address of the multicast group that the simulated host is to join, in the range of
224.0.1.0 to 239.255.255.255.
source-address: Address of the multicast source that the simulated host is to join. The value of this
argument should be a valid unicast address or 0.0.0.0. If the value is 0.0.0.0, this means that no
multicast source is specified.
vlan vlan-id: Specifies the VLAN that comprises the port(s), where vlan-id is in the range of 1 to 4094.
1-12