Remark Dot1P - HP E4510-48G Command Reference Manual

Default Level
2: System Level
Parameters
cpu: Redirects traffic to the CPU.
interface interface-type interface-number: Redirects traffic to an interface identified by its type and
number.
Description
Use the redirect command to configure traffic redirecting action for a traffic behavior.
Use the undo redirect command to remove the traffic redirecting action.
Related commands: qos policy, traffic behavior, classifier behavior.
Examples
# Configure the redirecting action to redirect traffic to GigabitEthernet 1/0/1 port.
<Sysname> system-view
[Sysname] traffic behavior database
[Sysname-behavior-database] redirect interface GigabitEthernet 1/0/1

remark dot1p

Syntax
remark dot1p 8021p
undo remark dot1p
View
Traffic behavior view
Default Level
2: System Level
Parameters
8021p: 802.1p precedence to be set for packets, in the range 0 to 7.
Description
Use the remark dot1p command to configure the action of setting 802.1p precedence for a traffic
behavior.
Use the undo remark dot1p command to remove the action of setting 802.1p precedence
Note that, when the remark dot1p command is used together with the remark local-precedence
command, the 802.1p precedence to be set for packets must be the same as the local precedence to
be set for packets. Otherwise, the corresponding policy cannot be applied successfully.
Related commands: qos policy, traffic behavior, classifier behavior.
Examples
# Configure the action to set 802.1p precedence to 2 for a traffic behavior.
1-10