Display Rip Database - HP E4510-48G Command Reference Manual

Default route cost
Verify-source
Networks
Configured peers
Triggered updates sent
Number of routes changes
Number of replies to queries

display rip database

Syntax
display rip process-id database
View
Any view
Default Level
1: Monitor level
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
Description
Use the display rip database command to display active routes in the database of the specified RIP
process, which are sent in normal RIP routing updates.
Examples
# Display the active routes in the database of RIP process 100.
<Sysname> display rip 100 database
10.0.0.0/8, cost 1, ClassfulSumm
10.0.0.0/24, cost 1, nexthop 10.0.0.1, Rip-interface
11.0.0.0/8, cost 1, ClassfulSumm
11.0.0.0/24, cost 1, nexthop 10.0.0.1, Imported
Table 3-2 display rip database command output description
Field
X.X.X.X/X
cost
classful-summ
Nexthop
Field
Destination address and subnet mask
Cost of the route
Indicates the route is a RIP summary route.
Address of the next hop
Description
Cost of the default route
Indicates whether the source IP address is checked on
the received RIP routing updates
Networks enabled with RIP
Configured neighbors
Number of sent triggered updates
Number of changed routes in the database
Number of RIP responses
Description
3-5