HP E4510-48G Command Reference Manual page 1326

22
IPC Configuration Commands
The display commands in this document display information of active nodes only.
For a centralized device, "local node" refers to a local device; for a distributed device, "local node"
refers to the active main control board.
IPC Configuration Commands
display ipc channel
Syntax
display ipc channel { node node-id | self-node }
View
Any view
Default Level
1: Monitor level
Parameters
node node-id: Displays channel information of the specified node, where node-id represents the
number of the specified node, in the range of 0 to 9.
self-node: Displays the channel information of the local node.
Description
Use the display ipc channel command to display the channel information of the specified node.
Examples
# Display channel information of node 6.
<Sysname> display ipc channel node 6
ChannelID
-----------------------------------------------
14 Prehistorical channel, NO.2
15 Prehistorical channel, NO.6
16 Prehistorical channel, NO.7
19 Prehistorical channel, NO.1
25 Prehistorical channel, NO.4
Description
22-1