S2C264: Station Axis Current Value Display Function; S2C265 To S2C288: Station Axis Displayed Unit - YASKAWA DX100 Operator's Manual

155507-1CD
DX100
8.6.0.4 S2C232: JOB AT CALLING MASTER OF SUBTASK BY INDEPENDENT

8.6.0.5 S2C264: STATION AXIS CURRENT VALUE DISPLAY FUNCTION

8.6.0.6 S2C265 to S2C288: STATION AXIS DISPLAYED UNIT

8 Parameter
8.6 Parameters according to Coordinated or Synchronized Operation
When master task is currently displayed:
1
Sub task 1 Sub task 1
Master
task
Sub task 2
When sub task 1 is currently displayed:
2
Sub task 1
Master
task
Sub task 2
3 When sub task 2 is currently displayed:
Sub task 1
Master
task
Sub task 2
0: One of the task jobs that are currently
displayed operates.
CONTROL
This parameter specifies the job which is called up when the master of the
subtask is called up by independent control.
0 : Master job
1 : Root job
Master Job: Job registered in the master control window
Root Job: Job activated by PSTART instruction
This parameter specifies whether the function to display the current value
of the station axis in the following units is valid/invalid.
0 : Invalid
1 : Valid
Rotary axis : Angle (deg) 
Servo track : Distance (mm)
Regarding whether to specify the rotary axis or the servo track, refer to
section 8.6.0.6 "S2C265 to S2C288: STATION AXIS DISPLAYED UNIT".
This parameter specifies the station axis displayed unit (bit specification).
0 : Display angle (deg)
1 : Display in distance (mm)
8-46
: Not operating
: Operating
Sub task 1
Master
task
Sub task 2
1: All task jobs operate.
RE-CSO-A037
477 of 554