S2C067 To S2C194: Cube Using Method - YASKAWA DX100 Operator's Manual

For material handling, press tending, cutting, and other applications
Hide thumbs Also See for DX100:
Table of Contents

Advertisement

DX100

8.4.0.5 S2C067 to S2C194: CUBE USING METHOD

8
Parameter
8.4 Parameters According to Interference Area
These parameters specify the coordinates for defining the cube. If the
user coordinates are selected, also specify the user coordinate system
numbers. Set cubic area referring to the cubic interference areas shown
below.
Coordinate specification
0
: Pulse (axis interference)
1
: Base coordinates
2
: Robot coordinates
3
: User coordinates
Coordinate No.: Specify the user coordinate number when selecting "3:
User Coordinates". 
Units: 1m
Precaution When Setting the Interference Area
It will be necessary to consider the following when setting
the cubic interference and S-axis interference areas. The
manipulator is processed to decelerate to stop from the point
where it enters in the area. Therefore, set the areas in
consideration of the amount of the manipulator movement in
the deceleration section shown in the figure below.
SUPPLE-
MENT
Speed
Movement
The move amount in the speed reduction section is
dependent on the moving speed of the manipulator at that
time:
8-37
Interference area
Deceleration
Stop
Speed reduction section
V = 1500mm/s  approx. 300mm
(Max.) 
V = 1000mm/s  approx. 160mm 
V = 30mm/s  approx. 3 to 4 mm 
V = 20mm/s  approx. 2mm
RE-CSO-A037
155507-1CD
468 of 554

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents