S2C437: Playback Operation Continuation Function - YASKAWA DX100 Operator's Manual

DX100

8.3.0.45 S2C437: PLAYBACK OPERATION CONTINUATION FUNCTION

8 Parameter
8.3 Mode Operation Setting Parameters
This function is used to decide where to resume the playback on the start
operation after suspending the playback and moving the cursor or
selecting other jobs.
0: Starts operation where the cursor is located in the job displayed at 
the moment.
1: The playback continuation window appears. Select "YES" and the 
playback resumes where the cursor has been located when the 
playback suspended. If "NO" is selected, the playback resumes 
where the cursor is located in the job displayed at the moment.
Table 8-8: S2C437
Parameter Setting
Value
Resumes where the cursor is located in the job displayed
0
at the moment.
Resumes where the cursor has been located when the
playback suspended OR where the cursor is located in the
job displayed at the moment.
<Example>
Suspended at step 0003 during the playback of job A
Displays job B
1
Starts operation
On the playback operation continuation window
• When "YES" selected, the playback resumes from
• When "NO" selected, the playback resumes from the
* When this function is valid (S2C437=1), a light blue cursor is displayed
at the instruction section of step where the playback has been stopped.
When "YES" is selected, the playback resumes where this cursor is
located.
MOVJ VJ=0.78
If a job has been edited or FWD/BWD/TEST RUN
operation(s) have been executed, the playback cannot
NOTE
resume where it has suspended. Also this function is
invalid if the reserved start function is set valid (S2C222=0).
8-29
Where the Playback Resumes



step 0003 of job A
current position in job B
155507-1CD
RE-CSO-A037
460 of 554