Parameters According To Status I/O; S2C235: User Output Relay When Control Power Is On; S4C000 To S4C015: Parity Of User Input Groups - YASKAWA DX100 Operator's Manual

For material handling, press tending, cutting, and other applications

Hide thumbs Also See for DX100:

Table of Contents

8.5 Parameters according to Status I/O

Parameters according to Status I/O

These parameters set the parity check or I/O setting for user input/output

This parameter specifies the state of the user output relays when the

control power is turned ON. Since the power OFF state, including

peripheral devices, cannot be completely reproduced, take note when

: Reset to the power OFF state

: Initialized (all user relays OFF)

These parameters specify whether to execute priority checks with

parameters when instructions covering the input group (1G#) are

executed. The instructions covering the input groups are as shown below.

• IF Sentence (JUMP, CALL, RET, PAUSE)

• Pattern Jump, Pattern Job Call

Parity bits are set as the highest level bits of each input group and are

written in even parity. If an error is detected during parity check, an alarm

occurs and the manipulator stops. Remains unchanged if no parity check

is specified.

Show Quick Links

Table of Contents