Specifying The Shift Value By Position Variables; Window Display - YASKAWA DX100 Operator's Manual

155507-1CD
DX100

6.4.4 Specifying the Shift Value by Position Variables

6.4.4.1 Window Display

6 Convenient Functions
6.4 Parallel Shift Job Conversion Function
The shift value can be specified using position variables by parameter
settings.
Parameter S2C652: SHIFT VALUE FOR PARALLEL SHIFT JOB
CONVERSION
0: Shift value by numeral/teaching (Initial setting)
1: Position variable shift value
A. FILE NO.
Specifies position variables.
B. SHIFT JOB NAME
The job which was shown in the JOB CONTENT window is set initially. 
To change the job, perform the following procedure.
Move the cursor to the conversion job name and press [SELECT]. The
JOB LIST window appears. Move the cursor to the desired job and
press [SELECT]. The PARALLEL SHIFT JOB window reappears, and
the job name which was selected is shown.
C. MODE
Specifies the conversion mode.
SINGLE (INDEPENDENT JOB CONVERSION)
Only the selected job is converted even if the selected job includes the
jobs called by JUMP or CALL instructions. Related jobs are not
converted.
RELATIVE (RELATIVE JOB CONVERSION)
Both the selected job and all the related jobs (the jobs called by JUMP
or CALL instructions) are converted.
For details of each conversion mode, refer to section 6.4.4.2 "Jobs
Targeted for Conversion" .
6-39
A
B
C
D
E
279 of 554
RE-CSO-A037