Axp010: Welding Instruction Output; Axp011, Axp012: Manual Wire Operation Speed; Axp013, Axp014: Welding Control Time; Axp015 To Axp017: Number Of Welding Control - YASKAWA DX100 Operator's Manual

155507-1CD
DX100

8.10.1.6 AxP010: WELDING INSTRUCTION OUTPUT

8.10.1.7 AxP011, AxP012: MANUAL WIRE OPERATION SPEED

8.10.1.8 AxP013, AxP014: WELDING CONTROL TIME

8.10.1.9 AxP015 to AxP017: NUMBER OF WELDING CONTROL

8.10.1.10 AxP026 to AxP029: TOOL ON/OFF USER OUTPUT NO. (Jigless

8.10.2 Handling Application

8.10.2.1 AxP002, AxP004: f1 KEY FUNCTION

8.10.2.2 AxP003, AxP005: f2 KEY FUNCTION

8.10.3 Spot Welding

8.10.3.1 AxP003: MAXIMUM NUMBER OF CONNECTED POWER SOURCES
8 Parameter
8.10 Application Parameters
This parameter specifies the beginning number (0 to 12) of the analog
output channel to the Power Source. "0" indicates that no Power Source
exists.
These parameters specify the manual wire operation speed as a
percentage of the maximum instruction value. Instruction polarity is
determined by the current instruction in the Power Source characteristic
file. The setting range is from 0 to 100.
These parameters specify the welding control time in units of minutes.
The setting range is from 0 to 999.
These parameters specify the number of welding controls. The setting
range is from 0 to 99.
system)
These parameters specify the user output number for the tool open/close
operation by specific keys.
These parameters set the output signal to assign for f1 key.
0: Not specified
1 to 4: Specific outputs for HAND-1 to HAND4-1
5: User output (No. is specified by AxP004).
These parameters set the output signal to assign for f2 key.
0: Not specified
1 to 4: Specific outputs for HAND-2 to HAND4-2
5: User output (No. is specified by AxP005)
This parameter specify the maximum number of power sources which are
to be used. The value is automatically set at start-up. No modification is
needed.
8-56
487 of 554
RE-CSO-A037