Special Playback Operations; Low Speed Operation - YASKAWA DX100 Operator's Manual

DX100

4.2.2 Special Playback Operations

4.2.2.1 Low Speed Operation

4 Playback
4.2 Playback
The following special operations can be performed during playback:
• Low speed operation
• Limited speed operation
• Dry run speed operation
• Machine lock operation
• Check mode operation
Two or more special operations can be performed at the same time. If
multiple operations are selected, the speed during playback is limited to
the speed of the slowest operation. Settings for special operations are
done in the SPECIAL PLAY window.
When the PLAYBACK window is displayed, move the cursor to the menu
area and select {UTILITY}  {SETUP SPECIAL RUN}. The SPECIAL
PLAY window appears.
The manipulator moves at low speed during the first step after starting.
After the operation of this step, the manipulator stops regardless of the
selection of the operation cycle and then low speed operation is canceled.
Even if the manipulator is stopped its motion during the low speed
operation, the low speed status would not be canceled before it reaches
the first step.
After one step operation, pressing [START] allows the manipulator to
move at the taught speed.
1. Select "LOW SPEED START" on the SPECIAL PLAY window.
– The setting alternates between "VALID" and "INVALID".
2. Select "COMPLETE".
– The window returns to the PLAYBACK window.
4-11
155507-1CD
RE-CSO-A037
200 of 554