S2C221: Speed Data Input Form; S2C222: Reserved Start; S2C224: Job Selection At Remote Function (Play Mode)8-18; S2C225: External Mode Switch - YASKAWA DX100 Operator's Manual

155507-1CD
DX100

8.3.0.21 S2C221: SPEED DATA INPUT FORM

8.3.0.22 S2C222: RESERVED START

8.3.0.23 S2C224: JOB SELECTION AT REMOTE FUNCTION (PLAY MODE)

8.3.0.24 S2C225: EXTERNAL MODE SWITCH

8.3.0.25 S2C227: EXTERNAL CYCLE SWITCHING

8 Parameter
8.3 Mode Operation Setting Parameters
This parameter specifies the units for speed data input and display.
mm/s : in units of 0.1 mm/s
cm/min : in units of 1cm/min
inch/min : in units of 1 inch/min
mm/min : in units of 1 mm/min
The specification can be done on the OPERATING CONDITION window.
0 : mm/sec
1 : cm/min
2 : inch/min
3 : mm/min
This parameter specifies whether a reserved start instruction from the
programming pendant is accepted or not. The specification can be done
on the OPERATING CONDITION window.
0 : Permitted
1 : Prohibited
This parameter specifies whether a job selection in play mode at remote
function is prohibited or not.
0 : Permitted
1 : Prohibited
This parameter specifies whether mode switching from the outside is
accepted or not. The specification can be done on the OPERATING
CONDITION window.
0 : Permitted
1 : Prohibited
This parameter specifies whether cycle switching from the outside is
accepted or not. The specification can be done on the OPERATING
CONDITION window.
0 : Permitted
1 : Prohibited
8-18
449 of 554
RE-CSO-A037